imthewalrus
Recruit
- Joined
- Aug 14, 2008
- Messages
- 3
I've been trying to remove the bottom paint on my 21' fiberglass Chris Craft with limited success. I've tried West Marine's paint remover which didn't seem to do much and I've also been trying to sand the remaining paint off with an orbital disc sander using 60-80 grit discs. It's extremely slow and I'm going through discs like crazy since they only last a few minutes or so and then are no good.
Is there an easier way? How about sandblasting - is that safe or would that hurt the gel coat?
Thanks!
Ronnie
Is there an easier way? How about sandblasting - is that safe or would that hurt the gel coat?
Thanks!
Ronnie