scottn83
Petty Officer 2nd Class
- Joined
- Aug 26, 2011
- Messages
- 187
Ok i have completed the rebuild of my 3.0L merc. I want to get it started before putting it back in the boat. I have tried to start it but it wont fire there is 12 volts to the coil after i figured out that you need to jumper were the starter wire that comes through the wiring plug which was 5 to 6. I still have not spark out of my coil. I have determined no spark from the coil with a timing light on the out put cable. I have used the same dizy, points and condenser that was in the previous block The engine started and ran before i tore into it so i cant see any problems with the electrical parts but something isnt right.
Any suggestions what else i may have missed?
Any suggestions what else i may have missed?