anamealreadyinuse
Seaman
- Joined
- Jan 28, 2012
- Messages
- 65
I am installing the Fishmaster Grab Bar and the instructions call for the stainless screws to be pre-drilled and secured with 5200. That is all fine and good but I don't always want the grab bar on the boat.
Is there a way to pre-drill and set embedded nuts in the floor for the screws/bolts so that I can remove the screws/bolts (and grab rail) entirely when I want?
I remember using some sort of nut that would embed in concrete so we could secure lag bolts for computer cabinets to the floor.
Does anyone know where I can get some sort of stainless nut like this or what its called if it exists?
Is there a way to pre-drill and set embedded nuts in the floor for the screws/bolts so that I can remove the screws/bolts (and grab rail) entirely when I want?
I remember using some sort of nut that would embed in concrete so we could secure lag bolts for computer cabinets to the floor.
Does anyone know where I can get some sort of stainless nut like this or what its called if it exists?