bardfromedson
Cadet
- Joined
- Mar 23, 2012
- Messages
- 24
Just finishing up putting my 85 aq260 back in the old sea ox after a rebuild. While wiring one of the oil pressure sending units back up I broke one of the prongs off. It had 2 prongs. The other one has a single wire that looks like a can with a round top. Pretty sure it goes to the oil pressure gauge. They both thread into a T that is piped into the block. At the end of the night I cleaned up the shop and pretty sure the broken one got tossed. Can anyone give me an idea of a replacement part. Also wondering what the broken one does. I read somewhere that on some engines this would be wired to cut of the electric fuel pump. My pump runs off the crank so can't see this being the case. Thanks in advance. I'm kind of stuck until I can figure this out.
Edit. Found an old pic of it.
Edit. Found an old pic of it.
Last edited: