Hi,
Great forum, I've learned a lot by reading and searching posts for the last couple of months.
I do have one question that I can't seem to find an answer for. I've got a Cobra SX drive and I'm replacing all the seals in my upper and lower case. I am having difficulty with the input seal on the upper case. I've removed the torx bolt from the end of the pinion gear, but I can't get the pinion and stub yoke to seperate. I don't have a manual yet (I'm trying to find a factory manual) but was hoping somebody on here could point me in the right direction. Is there a special tool required to get to the input seal?
Thanks in advance!
Great forum, I've learned a lot by reading and searching posts for the last couple of months.
I do have one question that I can't seem to find an answer for. I've got a Cobra SX drive and I'm replacing all the seals in my upper and lower case. I am having difficulty with the input seal on the upper case. I've removed the torx bolt from the end of the pinion gear, but I can't get the pinion and stub yoke to seperate. I don't have a manual yet (I'm trying to find a factory manual) but was hoping somebody on here could point me in the right direction. Is there a special tool required to get to the input seal?
Thanks in advance!