I started this project nearly 10 years ago. Between the Great Recession, moving, no money, & then no time it just didn't get completed. Now I have a little more time & money I am wanting to get it put back together & maybe get it on the water this year. I thought I did a good job for my first time doing any glass work & it looked good when it was finished but now that I have taken the cover off I noticed a few areas where it had bubbled up & spider webbed.
When I did it I replaced or re-built any bad stringers. Glued & screwed (exterior screws) the plywood to the stringers. Layered seems 3 to 4 times with fiber glass strips. Then fiber glassed the whole floor 2 or 3 more times.
My question is can I go ahead & lay carpet or do I need to grind this down & put down another layer of glass?
When I did it I replaced or re-built any bad stringers. Glued & screwed (exterior screws) the plywood to the stringers. Layered seems 3 to 4 times with fiber glass strips. Then fiber glassed the whole floor 2 or 3 more times.
My question is can I go ahead & lay carpet or do I need to grind this down & put down another layer of glass?