On the run
Recruit
- Joined
- Aug 26, 2016
- Messages
- 4
I feel sure this subject has been kicked around before, if so, here it goes again.
In attempting to remove the cable from the helm, the instructions say to remove the pin, then place the pin in a hole, then pull on the cable and turn the wheel. Clear enough, except the pin won't go in the hole. Actually, I found 2 holes but the pin won't go in either of them. What am I doing wrong?
In attempting to remove the cable from the helm, the instructions say to remove the pin, then place the pin in a hole, then pull on the cable and turn the wheel. Clear enough, except the pin won't go in the hole. Actually, I found 2 holes but the pin won't go in either of them. What am I doing wrong?