I rebuilt my GTS carb per service manual and Mikuni website. Poppet is set at 18psi. New Poppet valve with rebuild kit. High speed needle set to close per manual. Low speed is set to 1 - 1/4.
The ski starts and idles smooth out of the water. I can rev it to full throttle with no issues, but going from full to idle, it backfires through the carb.
I had to adjust the timing on the rotary valve only because it stuck to the cover when I removed the carb. I set it to the specs per the manual using a timing wheel.
I am hoping to take it out this weekend... Not looking good
The ski starts and idles smooth out of the water. I can rev it to full throttle with no issues, but going from full to idle, it backfires through the carb.
I had to adjust the timing on the rotary valve only because it stuck to the cover when I removed the carb. I set it to the specs per the manual using a timing wheel.
I am hoping to take it out this weekend... Not looking good