fishingfrenzy
Petty Officer 3rd Class
- Joined
- Sep 15, 2008
- Messages
- 94
I'm doing my first motor project and love it so far. I'm working on a 73 Johnson 2 HP, and wasn't getting spark so I dove in. The carb was rebuilt so that was clean. Looking under the flywheel, the electrical system has been replaced before (not sure when) but probably within the last 10 years. The point gap was set at .010 so I reset to .020. I guess my problem now is I'm not sure what to do next...any ideas?
Under the flywheel
Moving forward powerhead was taken off to replace the seal, is it supposed to be this dirty inside the casing and on the driveshaft?
Thanks much for any tips or suggestions!
Under the flywheel
Moving forward powerhead was taken off to replace the seal, is it supposed to be this dirty inside the casing and on the driveshaft?
Thanks much for any tips or suggestions!