BeachBum57701
Cadet
- Joined
- Jul 1, 2007
- Messages
- 6
Upon reading some of the forums my motor must be the Selectic Shift because it only has one control arm for throttle. I have the wiring diagram for this motor but it only shows power going from key to a box called "Leads to shift selector" with three wires. One wiring being power the other two go into a knife switch then into a forward or reverse shift solenoid. Do I just need have a toggle switch that puts power one key is on to either solenoid? Also, what does the knife switch do right in front of the solenoid? My direct email is jvsali@hotmail.com
Thanks tons
Thanks tons