Serial:
OG822332
1999
50ELPT
Story:
Drove out a mile or so, motor off, fished, started, moved, motor off, fished, doesn't start. Messed around looking for loose wires all over console and engine for 15 minutes, eventually started again so drove back to dock. Once at dock was able to start again once.
Symptoms:
1. Gas, volt, mph gauges do not turn on with key (except the two times it started).
2. The rpm gauge does work fine.
2. Trim/tilt on throttle does not operate.
3. Trim/tilt on motor does operate.
4. When motor was running the gas, volt, mph gauges quit moving almost immediately.
5. No power coming into the key switch.
6. There is power at solenoid, but not the key lead there of course.
7. The wiring harness plugs, connectors and motor itself appear and and very clean inside.
Is this a cdi problem (part no: 825098 1)? Is there a wiring diagram of the cdi or motor somewhere to diagnose?
Any other ideas on what to look for?
OG822332
1999
50ELPT
Story:
Drove out a mile or so, motor off, fished, started, moved, motor off, fished, doesn't start. Messed around looking for loose wires all over console and engine for 15 minutes, eventually started again so drove back to dock. Once at dock was able to start again once.
Symptoms:
1. Gas, volt, mph gauges do not turn on with key (except the two times it started).
2. The rpm gauge does work fine.
2. Trim/tilt on throttle does not operate.
3. Trim/tilt on motor does operate.
4. When motor was running the gas, volt, mph gauges quit moving almost immediately.
5. No power coming into the key switch.
6. There is power at solenoid, but not the key lead there of course.
7. The wiring harness plugs, connectors and motor itself appear and and very clean inside.
Is this a cdi problem (part no: 825098 1)? Is there a wiring diagram of the cdi or motor somewhere to diagnose?
Any other ideas on what to look for?