I cleaned and rebuilt the carbs this spring, checked the timing today and replaced the plugs.
I can get it to idle fine.
But when going into gear it drops rpm till it stalls, when in the boat is in the water.
I have followed the "Timing and Sync of Merc Inlines (to 1988)"
I have turned out the mixture screw out on each carb.
If I bump up the throttle it will stay running, rpm's have to be over 1000.
Any ideas on what to check next?
I can get it to idle fine.
But when going into gear it drops rpm till it stalls, when in the boat is in the water.
I have followed the "Timing and Sync of Merc Inlines (to 1988)"
I have turned out the mixture screw out on each carb.
If I bump up the throttle it will stay running, rpm's have to be over 1000.
Any ideas on what to check next?