I got more glass down. Finished the starboard side of the bow and most of the cut throughs and other patches that needed to be done. Had some minor air bubbles but over all pretty good. It's definitely alot stronger than the original hull. I ended up with one layer of 1.5 Oz mat, one layer of 1708, than layers of 12 and 6 inch tape over the chines. These pretty much ended up overlapping each other, giving 4 layers total. Once the stringers go in, a couple more tabbing of 6 and 12 to hold them should make the hull bullet proof. I also patched up the cracked area. I used 3 layers of 1708, one bigger than the other. This section will also have 1 layer of 1.5 Oz , 1708, 12 and 6 inch 1708 tape. When I scuff to do the next layer, is a DA with 50 or 60 grit enough or do I need to use the grinder with 40 or 36 grit? In the past I've laid everything at once or by the next day to have the chemical bond. But this project is pretty big. Mahalo, I'll post pics next week.