1968 Raycraft 15? hull repair concerns, as to being sealed from water under the floor.
1. I have damage in the center of the hull from a frozen roller, concrete ramp or rocky shores.
2. Is the bottom of the hull sealed fairly thick just above the bottom surface?
3. The bottom?s damage was showing matt and small cavities but there were no signs of water under the floor when I pulled the plug.
4. I fill the cavities with 3M Fiberglass Resin Jelly. Left a thick coating to lay matt in and covered it and plan to repeat with a 2nd layer of matt covered.
5. Is there any type of stainless or Etc that could be bonded to the center ridge to reduce this repeated wear.
6. I?ll post pics after adding the 2nd layer on matt and rough sand.
Thanks In Advance for any info!
1. I have damage in the center of the hull from a frozen roller, concrete ramp or rocky shores.
2. Is the bottom of the hull sealed fairly thick just above the bottom surface?
3. The bottom?s damage was showing matt and small cavities but there were no signs of water under the floor when I pulled the plug.
4. I fill the cavities with 3M Fiberglass Resin Jelly. Left a thick coating to lay matt in and covered it and plan to repeat with a 2nd layer of matt covered.
5. Is there any type of stainless or Etc that could be bonded to the center ridge to reduce this repeated wear.
6. I?ll post pics after adding the 2nd layer on matt and rough sand.
Thanks In Advance for any info!