Working on my first outboard m..otor and have some questions. I removed the carb to clean as the engine has sat for 3+ yrs. What are the recommended low and high speed needle settings? the low speed was set at 3 turns from the bottom. I am looking at buying a "Evinrude Outboard Motor Carburetor Kit 396701" kit to re install on the carb. Is this the correct kit? Has anyone installed a impeller/water pump on these motors? I haven't checked if it is any good. I ran the motor once but had rabbit ears on it which force water thru the cooling system.not sure if I have a bucket to run the engine in to see if it pumps water.