hello iboats! I need to figure out where I should start with fixing my boat. I was installing transom tabs and found dark brown moist pulp on the end of a drill bit i had used to drill holes for screws to hold the tabs. my heart sunk and i was very disappointed.
my biggest issue is cost. i have a thousand dollars and that's it to sink into this boat, (momma is already squawking that i am using a grand) and from what i've seen in posts, if the transom is bad, so is everything else.
so I may/will be doing a lot of scavenging with friends, countrymen and Romans when it comes to getting wood, fiberglass, foam, etc...
Where to start first?
and thanks for any and all help!
my biggest issue is cost. i have a thousand dollars and that's it to sink into this boat, (momma is already squawking that i am using a grand) and from what i've seen in posts, if the transom is bad, so is everything else.
so I may/will be doing a lot of scavenging with friends, countrymen and Romans when it comes to getting wood, fiberglass, foam, etc...
Where to start first?
and thanks for any and all help!