Hello,
One of my 25R76E starts only with choke nub pulled (closed throttle).
It starts very strong but dies after 2-3 sec.
I put new plugs and spark is very good.
Fuel is pumping and carb bowl was full of gas.
I disassemble carb and soaked it for over night. Tomorrow I will blow it with compressor and try again.
But if this does not help, what else can it be?
FYI:
I just fixed one spark thread with HeliCoil insert following exactly all the instructions. It was diying the same way before that, so i do not think it was it.
Thanks.
One of my 25R76E starts only with choke nub pulled (closed throttle).
It starts very strong but dies after 2-3 sec.
I put new plugs and spark is very good.
Fuel is pumping and carb bowl was full of gas.
I disassemble carb and soaked it for over night. Tomorrow I will blow it with compressor and try again.
But if this does not help, what else can it be?
FYI:
I just fixed one spark thread with HeliCoil insert following exactly all the instructions. It was diying the same way before that, so i do not think it was it.
Thanks.