Search results

  1. C

    How hard is it to work on the lower unit?

    I want to check out my clutch dogs and possibly switch the forward and reverse clutch dog. I have a manual, but it is not with my boat. Do you think I can just tear into the lower unit and make the switch? I'm fairly mechanically enclined and have the seal kit.
  2. C

    1986 75HP 4 Cyl. Merc. Does not idel very well.

    I have a 1986 75 HP 4 Cylinder Merc. The motor does not idel well and dies when I try to drive forward. If I choke the motor quick every 5-8 seconds the motor runs pretty good. As soon as I get up to about half throttle, the engine will take off without me choking it. I turned up the idel...
  3. C

    Wave height?

    http://cache.eb.com/eb/image?id=62985&rendTypeId=4 I always thought wave height is from the still water line to the crest?
  4. C

    Battery not charging. What could be wrong?

    1984 85 HP Force. My voltmeter on my depthfiner was at 11.5 volts while cruzing at 4000 rpms. This seams wrong. What could be wrong? 1. A wire came disconnected. 2. Stator. 3. Rectifier P.S. Engine runs fine, it just appears that the battery is not being charged.
  5. C

    Will these parts fit in my 1984 force 85 HP lower unit?

    http://cgi.ebay.com/ebaymotors/Force-Prop-Shaft-Clutch-Dog-Forward-Reverse-Gears_W0QQcmdZViewItemQQ_trksidZp1638Q2em118Q2el1247QQcategoryZ50439QQihZ023QQitemZ360038642813QQrdZ1QQsspagenameZWD1V Thanks
  6. C

    Tight Throttle

    The mechanism you move with your hand to adjust the throttle is fairly tight on my boat. When I give throttle it is not so bad, but when I am de-throttling, when I get to 1/4 thottle it almost feels like the thottle is stuck. I have to use a lot of pressure at the 1/4 throttle point to get to...
  7. C

    Long shaft or short shaft?

    Short shafts are 20 inches long and long shafts are 25 inches long. What are the reasons for wanting a short shaft or a long shaft?
  8. C

    How to install water pressure gauge and/or tempurature gauge.

    Here is a pic of a 85 hp force with two places labled A and B. Thanks to who ever provided this photo, I hope they don't care. 1. Is A what I used to install a water pressure gauge? 2. Can I use B to install a water tempurature gauge or a head tempurature guage? (I'm not sure if B is reading...
  9. C

    1984 Force 85 horsepower impeller or impeller kit?

    I found the impeller on Iboats for my motor. http://www.iboats.com/mall/partfinder/?*******=537601479&gd_grid_id=1342&gd_poid=242422&gd_row=22&**********=368809805 What about gaskets though? When I look for an impeller kit for my motor I can't find anything. Do I need the kit with all the...
  10. C

    Cracked Block. How long will it last, what to do? Pics Included.

    There is a small water leak coming from the block of my 1984 force 85 horsepower. I've circled the area it is coming from in red below. In the second picture, the water leak is coming from the tab area. The amount of water is pretty small at idel and low speads. After you get the rpms up a...
  11. C

    Minn Kota Copilot speeds?

    I know the current Copilot systems have a 1-10 speed control. I'm thinking about buying a copilot system, but does anyone know if minn kota is going to be coming out with a system that has more than 10 speeds? I might wait a year if they are.
  12. C

    What trim pump do I have? Pics included.

    85 HP force on a 84 bayliner. I'm not exactly sure what your the motor is, but it is either a 83,84, or 85. Is this one I can rebuild myself or one of those that the average person can't rebuild?
  13. C

    What kind of grease to use on the starter?

    1984 85HP force. The gear on the starter that pops up to engage the flywheel will not go back down. I'm pretty sure that all I have to do is take the starter apart a little bit, clean, and grease. What grease should I use? Do I need some sort of marine grease? I do not boat in salt water.
  14. C

    How to time engine is not in the clymers manual?

    I can't find it anywere in the clymers manual. Is it listed under some funny name?
  15. C

    What is this engine part? 1984 85hp force

    It isn't connected to anything and does not seem to do anything.
  16. C

    1984 1600 capri and 1984 85 HP force: Clunk under load

    When I put a load on the motor by using a lot of throttle, I get a clunk from the engine area. When this happend then engine does a little hop up and then drops back down fast. Any ideas how to fix this and what is causing it? I just put on a brand new 15 pitch propeller. With the old...
  17. C

    Is there something wrong with my new trolling motor?

    I've used a 65 lb thrust 24 volt powerdrive for years and got sick of the boat spinning in circles while landing a fish. So I bought a 55 lb thrust 12 volt autopilot. Going from 65 lb thrust to 55 lb thrust is roughly a 15% decrease in power. However, everything that I do with the 55 lb...
  18. C

    84 force troubleshooting: lower unit might be shot

    I have a 1984 85HP Force single piece lower unit with non thru hub exaust. As I was pulling into the dock today I went to put it in reverse and it didn't have any thrust. The engine just reved up. The boat got blown into shore so I pulled it back out to the end of the dock and tied it up. I...
  19. C

    What's the quality of this cover?

    Triton Trailerable Semi-custom with Straps - 100% polyester w/ vinyl coated topside with 3 year limited warranty. Special! Closeout Color – Priced 60% Off Retail More Details Made-To-Order Covers $203.00 Reg. $650.26...
  20. C

    Is this right? NADA boat weights.

    1983 starcraft SS 160 16' = 1500 lbs 1884 bayliner capri 1600 16' = 1090 lbs http://www.nadaguides.com/default.aspx?LI=1-24-38-5694-0-0-0&l=1&w=24&p=38&f=5697&m=1585&y=1983&ml=S&gc=MR&gtc=MR&d=1600175722...
Top