Search results

  1. S

    pee hole 35 hp mercury

    I have a 35 hp mercury outboard, sn 0b394125; I am trying to determine how/when the water should come out of the pee hole. the original manual states that it will start coming out when you put the ears on. however, mine does not come on until it has run a couple of minutes. It does not have a...
  2. S

    plastic bushing on top of drive shaft

    I have just installed a water pump and began installing lower unit, before sticking drive shaft into housing I looked up into housing and found a plastic, nylon bushing that had come off the top of drive shaft when removing it. It had stuck inside the housing. It fits down on spline. Do I just...
  3. S

    rubber drain tube

    Hi, I have removed my lower unit to replace the impeller, question is, there is a rubber tube that goes to a drain in lower unit. The tube had been plugged and placed doubled over where the gear shift rod goes thru the upper housing. It looks like it may have at one time attached to the lower...
  4. S

    warning horn

    Hi New to forum but read all the time. Have question??. Had boat out last week, 1990 , 35hp, quicksilver, and starter, bendex would just spin so removed cowl and with help of screwdriver it kicked up. Left cowling off while fishing so we could start it as needed. When Started in, warning horn...
  5. S

    no key start

    Hi I have just purchased a 1990 35hp mercury motor but do not have a key for the ignition, it is a 3 position, off, run, start, push to choke ignition on console. I have tried to jump start at starter and engine will turn over fine but no start or spark at plugs. Does the key activate some...
  6. S

    tilt/trim

    Hi, <br /><br />I'm new to forum so hope you can help. I have a 78, 140hp evinrude with tilt/ trim with 3 wires that does not work. I have access to a tilt/ trim with the 2 wires and everything else is the same. Can the two wire unit be adapted to work?<br /><br />Thanks<br /><br />Jim
Top