Search results

  1. T

    1986 150 evinrude

    I just bought this motor last week to play with. compression was around 80# on all six when i bought it. I decarbed, now it is 95# on all six. After running it a while i pulled the plugs and noticed one cylinder had a little bit of steam coming out. Head gasket??? Also, would it be in my...
  2. T

    How is my setup?

    17ft skeeter, 115 johnson fast strike, 22" raker, 50mph @6000 rpm. Is that a lot of slippage? Would a jack plate increase my speed or should I go to a higher pitch prop.
  3. T

    150 evinrude

    I installed a 115hp lower unit onto a 150hp to see if the smaller nosecone will increase my speed. Everything matches up perfectly. My only concern is exhaust. Will it resrict it to much? If so can I port it somehow? thanks
  4. T

    what's it worth?

    1986 Evinrude VRO 150 V6, tilt and trim. 85psi on all six cylinders.
  5. T

    motor swap

    I am currently running a 1996 115 johnson faststrike on my bass boat. I found a 1986 evinrude 150 v6. I want to swap motors, but before I do I would like to know the actual weight of the 150 hp. thanks
  6. T

    1986 evinrude 150 hp

    Does anyone know the dry weight of this motor? thanks in advance.
  7. T

    prop identification

    I was hoping someone could help me identify a prop. part# 4874602A4 23P on one side 5209 on the other. thanks
  8. T

    SPEED

    I have 15'6" Bayliner with 85hp Force. Does anyone else have the same set up? If so what kind of speed do you get out of it (GPS)? I can get around 45 mph. 3 blade stainless 19 pitch with tilt and trim. I don't have a tach so I have never ran it wide open out of fear of scattering the engine.
  9. T

    SPEED

    I have 15'6" Bayliner with 85hp Force. Does anyone else have the same set up? If so what kind of speed do you get out of it (GPS)? I can get around 45 mph. 3 blade stainless 19 pitch with tilt and trim. I don't have a tach so I have never ran it wide open out of fear of scattering the engine.
  10. T

    1995 200 EFI 2.5

    My brother-in-law scattered his motor the other day. Only one piston and cylinder is damaged. It looks like it was starting to melt and the rings came apart. What might have caused this? Can you run one cylinder lean? What is the easiest fix? What is the cheapest fix? Thanks in advance.
  11. T

    1988 yamaha wr500

    I have a fuel delivery problem, but i am not sure what it is. How do you test to make sure the fuel pump is working properly? I took the return line off of the carb and turned the motor over and fuel came out pretty strong for about 3 seconds and then it slowed down to a trickle. Is that...
  12. T

    stutter

    1986 85hp Force. When I give it full throttle it stutters for about three seconds and then takes off. I am running my mix a little heavy (40:1) because it was rebuilt recently. Any ideas?
  13. T

    motor won't shut down

    1986 85hp force. Finally got it running, now it won't shut off. Checked continuity at switch and terminal board between blue and white wires and everything is ok. If you turn the switch off and touch the motor it will shock the crap out of you and kill the motor. Any ideas?
  14. T

    walbro carbs

    1986 85hp force. Does anyone know if there is a difference between WE9-1 and WE9-2 carbs, besides the input "T" or elbow?
  15. T

    please help, wits end

    1986 85 hp. I have never had this motor run for more than 5 seconds. I have good spark at all 3 cylinders. I have fuel at all 3 carbs. Compression is between 115 and 120 on all 3 cylinders (new pistons and rings). Flywheel mark lines up with mark on intake when #1 is tdc. Rebuilt fuel...
  16. T

    flooding

    1986 85hp force. all three carbs flood like crazy. will faulty fuel pump diaphragm cause this? it acts like it has too much fuel pressure. is there a regulator for the fuel,besides the floats?
  17. T

    500 yamaha 1988

    how do you know if the engine is getting water? does it have a hole somewhere that spits water?
  18. T

    won't run

    1986 85hp force. When I try to start it sometimes it run for about a senond and then shut off. Other times it will backfire out of the exhaust. The carbs are full but it acts like it is running out of gas. The flywheel key is alright. Can it that far out of time.
  19. T

    serial number eurolarva

    force 85 hp. how do you know what year it is? 856X6L
  20. T

    tilt assist

    can you convert a tilt assist cylinder into a power trim system?
Top