Search results

  1. oldhaven

    My New 1970 Starchief

    That’s in the same ballpark as the 13x18 I have with the Merc 90 four stroke on my 67 Starchief. I had a 13x21 on it at first and that was too much pitch with a full boat. I do get a higher cruise and top end than you mention, but all in all that’s about what you can expect from these hulls in...
  2. oldhaven

    My New 1970 Starchief

    I have a similar Starchief with a 4 stroke Mercury. Just curious...what size and pitch prop are you using and what kind of performance does it give you?
  3. oldhaven

    Another Maine Starchief

    We’re in the new house after a long layoff. The boat was under cover and dry docked in the Maine woods for over a year, but made it through a summer, winter, and spring just fine. Changed the fuel filter put in fresh gas and it fired right up. While we are now on the water, our area of the...
  4. oldhaven

    Another Maine Starchief

    View from the front window during a storm from the south. 40-50 MPH winds that day
  5. oldhaven

    Another Maine Starchief

    the Katahdin going by the island to the west. The whole island was only 200 feet long.
  6. oldhaven

    Another Maine Starchief

    In mid August we rented a camp on a little island in Moosehead Lake for a week. It was just a mile from Greenville where we put in so it was easy to get into town for shopping and shore time. The Starchief performed great. On the trip when we moved in we had a full boat with 3 adults, two big...
  7. oldhaven

    '69 offshore rebuild- BMerr

    The early SC side panels did not connect to the gunwales except at the front through the consoles or cabin bulkhead and the back through an aluminum brace. I tied the short panels to the gunwales with the seat brace aluminum, since the package tray is not the best brace as it is at approximately...
  8. oldhaven

    Another Maine Starchief

    I had some weather delays but now have the new tank installed and the deck and side panels back in place. I put on the new enclosure and finally put in the woven vinyl carpet I had planned on using last fall before the tank problem. Maybe a bit too stripy, but it's nice on the feet. Just a...
  9. oldhaven

    Another Maine Starchief

    This will look like a time warp, but I took these pictures yesterday. Finally getting the new tank in to replace the leaky one. it took 4 hours to take out the sidewalls and deck, and another two to fit the new tank, which is the same model but slightly longer. I will be refinishing the deck and...
  10. oldhaven

    '69 offshore rebuild- BMerr

    You will have trouble finding a transom saver that fits the lower unit profile on these new Merc's. I use one of these instead: It keeps the strain off the tilt cylinder. Strictly speaking, Mercury does not feel anything is needed, but I just feel better about using something to hold up the...
  11. oldhaven

    1972 Starcraft Chieftain Restoration

    I used an extrusion called a division bar between the deck panels. It has a small low face above the deck that will not trip or hurt bare feet and the lower flange is wide enough to rivet through. I got the 3/4" but it is available in 1/2" . It is not that much more expensive compared to the...
  12. oldhaven

    Starcraft on C-list/ebay!

    Here one for g0nef1sshn 1989 Starcraft SFM160 - $4500 (Central VT) https://vermont.craigslist.org/boa/5845090606.html
  13. oldhaven

    Another Maine Starchief

    Just an update so the project thread is still alive. Nothing much to report boat wise, as the enclosure is still getting tuned and adjusted so it fits correctly. As I mentioned elsewhere I will likely have to plow a place in the yard to store it. My wife and I have been up north on the...
  14. oldhaven

    Another Maine Starchief

    Progress being made on the canvas top. It's not done yet, and these pictures are of it not yet fastened down, so it looks loose, but I like it so far. There will be a back panel with a window that closes it in from the splash well header header forward, and all the panels have zippers so I can...
  15. oldhaven

    Another Maine Starchief

    While we are up here this week I took the opportunity to unite the aluminum and riveted brother and sister in the family. This makes for an interesting picture, but probably won't happen often since the truck has terrible rear traction on ramps, a lot of diesel torque causing wheel spin on even...
  16. oldhaven

    Another Maine Starchief

    Just about a year after towing the Chief home, I towed it back up North and yesterday had my goal of getting it into Moosehead Lake completed. We put in at Greenville and did a round trip run up the Lake to Rockwood and Mt. Kineo. The boat was great, and handled the slight chop easily at a best...
  17. oldhaven

    Another Maine Starchief

    Up north this week and if the wind and weather cooperate I hope to get the boat into Moosehead this week. Meantime the Chief is attracting admiring stares from the neighbors. Ron
  18. oldhaven

    Another Maine Starchief

    My friendly dealer lent me a Merc 13 x 18 Vengeance prop to try. He had warned me that I would be over propped at 21, and rubbed it in a bit. I went out this morning and everything is much better. 41 MPH at 5750. I am putting in a URL for a youtube video of the test. I don't know how to embed...
  19. oldhaven

    Another Maine Starchief

    Went for a second trip today, and took my wife along, duplicating the Kennebec first trip for another 20 miles. She was very pleased with the seating, footrest, and even the terlet got some use. I managed to get a few stills, but when I tried to get her to take a holeshot video, she was not...
  20. oldhaven

    "are you sure you want to leave this page" pop up

    I am getting this annoying pop up when I am going from one Iboats forum page to another or doing a search. It is intermittent, but happens more often than not.. I believe this is a internet explorer pop up that is used when a user is filling in a form to keep from losing work and data, but I...
Top