Search results

  1. R

    Looking for steering and remote control for 1966 Johnson 40 hp

    Hello, I am in search of a remote control with electronic shift for a MODEL RDSL 28B SERIAL NUMBER J2685547 1966 Johnson Super Seahorse. Also steering cabels. Any information is appreciated. All the Best, Nick 8057047816
  2. R

    1986 evinrude15hp need help how to reassemble gear case tips

    I have most of the parts installed up to the clutch dog I've read that I'm supposed to install the clutch. dog First and then slide the prop shaft with the screen and the 2 ball detents into the clutch dog I see one side is kind of ground down to a lot easier access but I still have trouble...
  3. R

    prop spinning on prop shaft prop bushing bad? cant find one E15rcde 198615hp

    like the title the prop is spinning on the shaft i think the bushing is bad. would this also cause the the motor to wind down and die while in forward? because i was about a mile from the launch site and it wound down and died. i could start it again first pull in neutral and run the motor in...
  4. R

    grommet installation 1986 15hp evinrude

    im not sure which way to install grommet on the water tubes for my motor which direction do they go the small diameter opening down in the exhaust mounting plate or the larger diameter hole do i mate the small hole with the block or the large hole this is all i need to know to start putting it...
  5. R

    broken bolt exhaust housing

    i have an 86 15hp evinrude and when trying to inspect the water and exhaust rubber grommet for the upper water tube i twisted on bolt off the one that is next to the exhaust tube. it was corroded and i should have know better than to use force. my question is do i really need to remove or can i...
  6. R

    1986 evinrude starts but dies quickly 15hp pull start

    I have an Evinrude its 15 horsepower 1986 I have recently rebuilt the carburetor added a new fuel pump water impeller and spark plugs the motor will start but it will only run for 5 to 10 seconds before it dies I did all this work after I got stranded in the ocean after a few mile trip the motor...
  7. R

    1986 evinrude starts but dies quickly 15hp pull start

    i just installed a new fuel pump on the motor and the line that goes to the fuel pump its a larger diameter than the original line the motor starts bur only runns for a few seconds and then it dies and it wont start again until I choke it and prime it again. what could be the problem any help...
  8. R

    outboard bogs down and dies and wont start after 20 min of running it e15rcde

    hi new to forums. i have a 1986 evinrude 15 hp the model number is e15rcde. the last two times I've taken my boat out fishing in the ocean the motor seems to run fine on my way out starts after i go to a few spots then after a long run it will start to slow at full throttle until it finally...
Top