Search results

  1. R

    Montgomery ward sea king starter recoil

    Hey everyone, I just recovered a barn find 1974 Sea King VWB 52010 in really good condition but need help finding a starter recoil assembly as the entire assembly is missing. After doing some research sounds like this is a re branded Chrysler motor. Is there a Chrysler motor model to compare...
  2. R

    timing base issue on 72' Evinrude starflite

    I am having a problem with my 72' Evinrude Starflite 100hp where the timing base will seize when the engine warms up. I don't think the engine is overheating because its not extremely hot to the touch and the high temp alarm doesn't go off. I am getting about 15 psi before the thermostat opens...
  3. R

    Pulse pack problems... Trigger testing...

    So i got myself into a little situation today when I installed my new CDI pulse pack. I followed CDI's instructions and removed the clipper circuit but it ran worse then before I replaced it then died altogether. I was thinking it may be the trigger so I am going to try striking the black/white...
  4. R

    pulse pack upgrade 72' 100 hp

    I am repalcing the pulse pack on my 72' evinrude 100hp and I got the CDI model I noticed it said to remove the clipper circut. Just wanted to confirm that was true. Also is there anything else I need to consider or take note of before I swap the pulse pack out?
  5. R

    72 evinrude misfire

    I need some advice on my 72 100hp I am getting a misfire and no start after the motor has warmed up. Pulse pack is original to the motor (no im not joking) when i pulled the flywheel off i noticed the trigger and distributor have small cracks in them. I noticed when I fire it up cold it has a...
  6. R

    72 rude 100hp low speed issue

    Re: 72 rude 100hp low speed issue Ok so got the flywheel off and here is what i found. The rotor and distributor look like that have ware but there is a crack between every contact point on the distributor (see photo) Also not sure if the rotor is worn down or suppose to look like this (see...
  7. R

    72 rude 100hp low speed issue

    So I just got my restored 72 Glasstron V163 in the water for the first time after it had sat in a boat house for almost 10 years un touched but im having a few issues. first it was dumping gas everywhere but i just rebuilt the carbs and it was a night and day difference and seems to run ok when...
  8. R

    need help with 72 Evinrude Water pressure gauge and tell tall install

    So I am finally getting around to working my 72 100hp Evinrude (100293R). I wanted to add a tell tail to it but i noticed that i don't have the flat spot on my block that others tap into in the FAQ's. Can i tap into the same spot as others have without that flat spot or will the wall be to thin...
  9. R

    noisy idle with a 1972 Evinrude

    Hey guys I am new to the forum and in need of some help. I just picked up a 1972 Glastron V163 with a Evinrude 100hp (100293R) and it's in great shape for it's age due to the fact it has hardly been used. But due to the fact it sat in a boat house most of its life probably wasn't that great for...
Top