Search results

  1. S

    Stringer conversion

    How can I turn a hydro-mech into a mechanical shift
  2. S

    Who can id my mercruiser

    Outdrive serial no 2005765 motor 181/462 is it a mercruiser II or a 1A/1B/1C (EZ shift ) what's the exact year and model its between 1964-1967 I know it was white originally and has full power tilt ( no trim ) 110 hp
  3. S

    Johnson 1997 spl

    Alright I've got a Johnson 115 spl v4 the powerhead is shot as a piston ring broke I also have a 90hp v4 from about 1984 I don't know the model number plate is gone I was wondering if I can use this powerhead on the 115 with the carbs off the 115 and produce 115 horsepower or is there something...
  4. S

    Really tough question

    I have a 35 hp Johnson and after installing a lowerunit off another motor it has neutral the same but forward is reverse and reverse is forward it will accelerate to full speed in reverse when the selector is put in forward and when the selector is put in reverse it goes forward at a moderate...
  5. S

    Old mercury

    This is a 1950 super5 How do I get the plate I front the impeller off there is two holes in it do I need a specal puller or is it threaded in if so would it be lefthand thread also can I get this impeller at my local merc dealer or should I go to oldmercs.com
  6. S

    Clockwise vs counterclockwise

    I have a boat with two sterndrives 140 mercruisers and the outdrives were stole off it (before I got it) and I just happen to have two single boats with rotten hulls and was wondering what would happen if I put the two clockwise rotation drives on the same boat
  7. S

    Mercruiser manuals

    Hello I need the mercruiser Service manuals #1,#2 and #3 if someone has links for these on 4shared or in a downloadable form that's comparable please post them below this would be much appreciated
  8. S

    Ford 302 omc

    What can I use in its place the drive is a 76 electric shift I have some 305 and 350 chevs but also a electric shift inline 6 with outdrive and a 85 stringer 305 and drive will any of these fit and give me enough power the ford that's in it is 190 hp the boat is 22 ft
  9. S

    84 stringer seals

    I have a 1984 stringer and just ordered three seal kits for it as all three housings were leaking I was wondering if there is a manual I can get somewhere with instructions for replacing these as it looks to be a very tough job
  10. S

    Water in oil

    Just got a new 1983 merc 898 198hp it has water in the oil ( in the block ) I was wondering how I can test to see what this is from a cracked block,head,head gasket,exhaust gasket or something else the previous owner never changed the impeller and the engine overheated after they had the...
  11. S

    Engine swap

    I have a 1984 mercruser with a blown block (305) I also have a few later blocks (newer than 1986). What I was wondering is if you can swap these in. In any way because of the change in the rear oil seal or if it would be easier to get a older engine with the two piece oil seal.
  12. S

    Johnson 50 housing

    I have a manual shift 1984 50 horse Johnson and the gears are shot but I also have a 1973-1979 evenrude 50 horsepower that I think is a hydraulic shift I was wondering can I take the gears out and put them in the Johnson bottom end as I can see the impeller housing is different along with the...
Top