Search results

  1. R

    Yamaha 6hp Bogs down under load

    2005 Yamaha 6HP 2 stroke Outboard starts, revs well and pumps a good jet of water but once the motor gets warm after about 10 minutes of running in gear it starts to bog down. If I take it out of gear it revs well but as soon as I put it back in gear it bogs down again. Possible causes anyone?
  2. R

    Yamaha 6HP Schematics Parts List

    I cant seem to find a Schematics parts list for my 6HP Yamaha 2005 model No 6M8-BO can anyone send me a link please?
  3. R

    Yamaha 6hp cut out

    My Yamaha 6hp 2006 model cut out whilst out fishing yesterday but would restart after a few minutes. I have notice that no exhaust was coming out of the 2 small holes under the engine. Is there supposed to be exhaust coming from here? could this be the cause of engine cutting out? Thanks
  4. R

    6hp Yamaha only pumps water with muffs on and not in barrel or Sea

    My last impeller on my 2005 6hp 2 stroke Yamaha disintegrated so I replaced it with a new one and for some reason it pumps water very strongly on the muffs but will not pump at all in a barrel of water or when I took it out to sea today. Whats going on?
  5. R

    2006 Yamaha 6hp fuel mixture

    I have just purchased a 2006 Yamaha 2 stroke 6hp outboard and there is some confusion as to what the fuel mixture should be! Some forums say 50-1 some 100-1. Can anyone confirm what it should be please?
  6. R

    Mariner 4hp Year please?

    I have searched the web but cant find the year for my Mariner Outboard, can anyone tell me please? Mariner 4M S/N 6E0-S-084142 Thank you
  7. R

    Evinrude 15hp slow down at full Throttle in Gear

    My 1988 Evinrude 15hp 2 stroke seems to slow right down when I throttle up in gear. Out of gear it runs fine and does not loose revs! I have new coils, new power pack, carb has been overhauled. Fuel has been left in the carb for a year since it was last overhauled!
  8. R

    1986 Mariner 4hp Impeller?

    Hi I want to replace the impeller on my 1986 2 stroke 4hp Mariner 4A 6E0 S 084142 Is this the correct impeller to use.... Impeller For Yamaha F4A 4A 4B 5C Outboard Water Pump. 6E0-44352-00 | eBay Thanks
  9. R

    Mariner 4hp Wash Screw?

    Hi I have a 1988 4hp mariner which has been a very reliable little engine. near the bottom of the leg are 2 screws, 1 is for oil and the otherone say "WASH" does anyone know what this is for? Thanks Paul
  10. R

    1988 Evinrude 15hp loses Power when at full Speed

    My 1988 Evinrude 15hp engine is losing power when at full throttle. It will go fast for about 30 seconds but then slows right down instantly The engine does not cut out when this happens, it just slows right down and then it will immediatly pick up again for another 30 Secoconds and slow down...
  11. R

    Evinrude 15hp 1988 Running Problem

    1988 Evinrude 15hp Rope Start Model BA15BACCS S/N R1787299 Work Carried out so far:- Carb stripped cleaned and rebuilt, New Plugs New Engine oil New Fuel Lines and primer Bulb Engine Decarbed with Sea Foam Very good compression in both cylinders Engine is hard to start when cold but once...
  12. R

    Evinrude 15hp 1986 Hard to start when cold

    I am finding it hard to start my 2 stroke 15hp 1986 Evinirude, it takes about 10 pulls to get it going when its cold, but once it has run for a minute and I shut it off, it will then start very easily with 1 pull. I have good compression New Champion Plugs correctly gapped Had the Carb rebuilt...
  13. R

    Evinrude 15hp 1986 Run for a while then stopped

    Hi can anyone please give me some advice. I have a Evinrude 15hp 2 Stroke 1986 outboard and was using it on a rib today for the first time using a 50-1 mix. The engine was running fine for about 1 hour then I stopped on the beach for a couple of hours for lunch and then it would not restart...
Top