Search results

  1. A

    Lower Unit Rebuild complete

    I wanted to thank all that helped with advice, tips, schematics, and everything else on my lower unit rebuild. It did cost around as much to replace all gears, bearings, seals, longshaft, and bearing housings, as buying another unit, but my intent was to rebuild for the knowledge for the next...
  2. A

    Shift rod height verification...LU reassembly.

    Just verifying on for my 1987 Johnson 90 reassembly. 21 27/32? Yes, I've looked at the sticky.My engine year is not included. http://forums.iboats.com/forum/engine-repair-and-maintenance/engine-frequently-asked-questions-faq/162233-shift-rod-heights-1973-thru-1981-50-235hp-by-obj?t=158088...
  3. A

    Pinion bearing install

    1987 Johnson 90 v4 Quick question. Does the pinion bearing seat automatically when installing? Seloc does mot specify. I know the bearing has a slight taper that leads me to believe that it'll stop where it should.
  4. A

    Is bearing carrier scrap metal?

    Removing bearings from the bearing carrier, i noticed a piece missing off the o-ring channel wall. Is it headed to the scrap heap? Is it repairable?
  5. A

    Prepping to change all bearings in lower unit

    I've gotten all the parts i need on my lower unit rebuild (1987 johnson 90). Any advice or tips on pulling the bearings? Iknow the pinion bearing need a special tool, unless anyone has a procedure to share. I'm thinking the carrier and shift assembky bearings are going to be a pill to pull.
  6. A

    Pitting on driveshaft

    1987 Johnson 90... I need to ask...is this driveshaft a goner?
  7. A

    1987 johnson 90 lower unit repair shopping list

    After disassembling the lower unit, I found a few chipped teeth on the forward gear and rounding of the clutch dog. I'm going to order the forward/rear/pinion/clutch dog kit, the seal kit, a shim kit, and I threw in a water intake screen because I melted a small hole while heating the bullet to...
  8. A

    [1987 Johnson 90 V4] Prop Shaft removal

    Hello to all members. I'm working on my lower unit and am stuck and I hope someone can share some knowledge with me. First of all, I have a 1987 Kruger Baymaster with a Johnson 90 V4. I have the seloc but not a factory manual. The engine model number tag on my engine has long dissapeared...
Top