Search results

  1. P

    1991 Yamaha 150 will not idle this season

    Hi all: I have a 1991 Yamaha 150 on my Grady White. Ran flawlessly 7 months ago when I put it up for winter. Over the winter season, did my usual stuff like clean the spark plugs and change the water separator and lower unit oil. Ran well on the muffs 3 weeks ago in driveway. Took it out 1...
  2. P

    1991 Yamaha 150txr normal idle temps?

    Hi all: I have a 1991 Yamaha 150 on my Grady White Tournament. Last November, I was running it on the muffs in the driveway when the overheat alarm began. Temp gun indicated 200F. Located a kink in the hose. Replaced both thermostats to be cautious. Impeller had been changed 9 months...
  3. P

    Yamaha 150 ETD overheat warning buzzer on muffs

    Hello All: I have a 1991 yamaha 150ETD that issued a overheat horn and light while running on the water muff in my driveway. Engine was running at idle approximately 5 minutes while I was cleaning garage and appeared very normal with a healthy stream of water shooting out of the engine as...
  4. P

    Installing plywood fuel tank supports in my Grady, should I use 5200 or epoxy?

    Title basically says it all. I am installing 8 plywood pads on floor of fuel tank compartment to rest my new fuel tank on. This method is what the tech department at GW recommended. I will cover the pads in 1/8" silicone rubber sheet. My question is should I glue the pads onto the tank...
  5. P

    Grady white Tournament 19 fuel tank installation

    Installing a new tank in my 1992 Tournament but cannot figure out if the tank sits directly on top of the PVC drain pipe that runs the length of the compartment. There were 3 bulb type rubber seals that ran up and over pvc pipe and accross the compartment side to side. The anchoring system for...
  6. P

    Can't get fuel tank out of my Grady White Tournament 19...

    Greetings All: My winter 2011-2012 project is to remove the fuel tank on my 1992 Grady White because of suspected leak. Everything has been removed and tank is empty of course. Problem is that the tank measures 64" long and the tank opening is 62.75 inches. I have already cut 3/8" off the...
Top