Search results

  1. T

    1994 evinrude head bolt torque specs please help

    replaced the head gasket and Need to know the torque specs for the 6 head bolts. Could not find much info on these motors. One place said 10-12 foot pounds but man that seems low. Any help is greatly appreciated .
  2. T

    Proper motor mounting height??

    I searched arround a bit and could not come to a definite answer, so I'll ask. Should the bottom of my cavitation plate be in line with my motor pod bottom or in line with the bottom of the toon? My toons are about 6 inches lower than my motor pod. It's currently inline with the motor pod and...
  3. T

    Flo torque hubs?..

    I have a flo torque iii on my opti 75, went to my local marine shop to get a extra drive sleeve to have on the boat just in case I need one. The guy sold me a flo torque ii and said it will work for the flow torque iii. Is this correct? Why would there be differant part numbers for the sleeves...
  4. T

    Mercurys smartcraft

    Not sure if this is the right place to post. Anybody got one of these smartcraft gauges? Which one and How do you like it and what don't you like about it? Thinking of getting one for my 06 opti 75.
  5. T

    Prop question??

    I have a 06 optimax 75 dfi. I noticed the prop has a little play fore and aft, and up and down. Flo torque iii design. Is this normal? Mixed feelings from reading other posts. Just would like a simple yes this is normal or no this is not. Thanks. Also can I use a regular spline prop. Or must...
  6. T

    Vapor separator drain screw

    2006 75 hp Optimax . I pulled both thedrain screws on the vapor separator to remove any water/contaminets, the o rings where not on the screws. Screwed both back in when I was done and the filter side sealed with no leaks, but the float chamber side will not seal I keep getting a trickle out of...
  7. T

    starving for fuel...plaese help!!!

    hello, i have a 1979 115hp inline 6cyl. motor has been running great for past 6 months. all of a sudden i was heading back to the ramp after being out all day and it started to loose power. i was running at about 4500 rpms and it bogged dowtn like it was starving for fuel. i backed off the...
Top