Search results

  1. N

    1995 15hp Johnson, parts left over

    I had my engine rebuilt and am assembling a year later, but with three parts left over. Any ideas where they go would be appreciated. The little metal bushing was under the carb area and fell out when I tilted the engine, so it may have been there for decades. The big ring is a brown plastic...
  2. N

    Thru-bulkhead to bell housing gear lube monitor hose ID

    Does anyone happen to know the inside diameter of this hose? Should I use a Mercruiser part, or will good gas proof hose work OK? Is it hard to install with the out-drive in place, any tips? Thanks! -Chris in NW Ontario
  3. N

    1980 150 Black Max leaking head gasket? (photos)

    Hi, I have been experiencing missing when motor is cold and on low RPM's. Spark plugs show milky grey liquid (water). No water in fuel, so I pulled a head just now and attached pics. I have a new head gasket to install, I just wanted to confirm with more experienced folks that this is the...
  4. N

    1995 15 hp Johnson, top cylinder missing

    Hi, my 1995 15 hp Johnson has a high speed miss on the top cylinder, I think. The boat runs fine at low speeds, but will miss off and on every few seconds at high speeds. Backing off on the throttle will actually make the motor run a bit better, but nothing like what it did years ago. If I stop...
  5. N

    Evinrude 4.5 charge coil current?

    Hi all, I'm new to the group, though it's saved my bacon more than once, thanks. My question concerns my Evinrude 1985 or so 4.5 HP kicker on my sailboat. I am thinking about putting a charge coil (part #0581635 I think) to top up the batteries while away from shore power. Does anyone have...
Top