Search results

  1. F

    1998 Mariner 200 MAG EFI

    I think my trim sender is bad. I disconnected the wire that runs up into the motor and grounded it. The gauge responded by moving from pegged up to pegged down. Would this indicate a bad sender? Also, I'm having trouble locating the sender for this motor. The serial number is OG740775. Thanks...
  2. F

    Stator question

    I have a Johnson GT 150 model # J150STLCOS Serial # J6130519. I'm trying to figure out if it has the 9 amp or the 35 amp stator. Is there any way to tell which, without pulling the flywheel? Thanks in advance.
  3. F

    johnson 150 problems at 3800 rpm

    I have a 1986 Johnson 150. It runs perfect up to 3800 rpms. as soon as it gets to 3800 it starts cutting out, like a dead miss. I can throttle back a little and it runs fine. I recently replaced a power pack on one side to cure another problem i was having. Could this be a problem with the...
  4. F

    1986 Johnson 150 GT

    Let me start by saying that I am new to the site, and boat ownership. I don't know very much about out boards. I just purchased a 85 Ranger with a 86 Johnson 150. When i went to look at the boat the owner put the muffs on and fired it up. The motor started, but was doing this irregular sorta...
Top