Search results

  1. B

    Outboard quits

    I have a E25RLESB Evinrude. It has new coils, new power pack,new fuel pump,a carb kit,anbd new tank and hose. I recently replaced the rear prop shaft seals and was doing a test run today. Ran fine all AM. Ran at wot and idled no problems. 1 or 2 pulls on the rope got it started. While idling...
  2. B

    pull start kick back

    I have a 25 hp Evinrude pull start model E25RLESB. 1990. When I pull start the motor It kicks back almost pulling the rope out of my hand. Once running it idles fine, goes to wot fine, and runs at wot fine. What would cause the kickback? New wp, fp, both coils, and a power pack. Take care and...
  3. B

    1990 Evinrude prop

    I have a 25 HP Evinrude 1990 model E25RLESB outboard. What would be a good prop for this motor. I have it on a 15.5 Smoker Craft, all open with tiller steering. mainly for a 2 person fishing boat. Lots a trolling . Also some long runs. I have a manual on cd but it is so hard to find anything on...
  4. B

    25 hp Evinrude prop

    I have a 25 HP Evinrude 1990 model E25RLESB outboard. What would be a good prop for this moter. I have it on a 15.5 Smoker Craft, all open with tiller steering. mainly for a 2 person fishing boat. I have a manual on cd but it is so hard to find anything on it. Thanks TJ
  5. B

    spark advance

    I am having some pre ignition on my E25rlesb 25 Evinrude. to set the advance, I have a recoil starter by the way. The only mark I have is on the starter and is a V pointing up./ I also have degree marks on the flywheel in 2 places. I is marked elec cd, the other is marked cd. I have found the...
  6. B

    Torque

    I am at a loss. I have a E25RLESB 1990 hp Evinrude. I have a manuel on cd but it is very hard to find anything on. What is the torque for the flywheel nut and the head bolts. also need tightening patterns. Thank you very much TJ
  7. B

    25 hp convert to elec start

    i have a 25 hp 1090 rude that I would like to convert to elec start. I'm not to worried about going through all the Evinrude safety features and wiring setups. I just would like to push a button and have it start. After heart sugery my chest muscles aren't what they used to be. Model#E25RLESB...
  8. B

    25 HP Evinrude timing

    Having some bad recoil when pull starting my 25 HP Evinrude 1990. Has a new fuel pump, carb,power pack and coils. How dom you set the timing? Take care TJ
  9. B

    At a loss SOLUTION

    1990 25 hp Evinrude. After putting in a fuel pump kit, carbkit, waterpump rebuild,and having a new power pack installed. The motor still didn't run right. I was told the slow mode was taking over. I don't have 1.Had a sugestion that it was the thermostat.???. Consultin with my shop mechanic he...
  10. B

    At a loss continued

    1990 25hp evinrude, tiller, pull start. Rebuilt fuel pump, rebuilt water pump, cleaned and replaced needle vale on carb,had a new power pack installed. and was told the coils are ok. Took it out today. It ran fine until after a long troll ;1/2 hour or so . I throttled up to go back up river,the...
  11. B

    At a loss

    1990 25hp evinrude, tiller, pull start. Rebuilt fuel pump, rebuilt water pump, cleaned and replaced needle vale on carb,had a new power pack installed. and was told the coils are ok. Took it out today. It ran fine until after a long troll ;1/2 hour or so . I throttled up to go back up river,the...
  12. B

    Fixed

    My Evinrude 25 (1990) would start to run then die over and over. I replaced the fuel pump as the diaphragm return spring had collapsed. No Good still did it. Put in a carb kit and cleaned out the carb. Replaced plugs, fuel lines,and bulb and hoses.No luck. Gave up and took it to the repair shop...
  13. B

    90 Evinrude 25 hp revs and dies revs and dies

    Had a problem a couple weeks ago. The motor would go to 1/3 throttle and die and just repeat itself. I found a problem in the fuel pump, the diaphragm return spring had fallen over. I put a fuel pump kit in and a carb kit also a water pump kit. Trying it out today it ran very strong at full...
  14. B

    25 hp idle problem

    I have a 25 hp 1990 Evinrude. I recently replaced the water pump and rebuilt the fuel pump. In testing the motot out this AM the water pump worked fine. The mptor would run at a fast idle and full power and ranges inbetween but wouldn't idle down as far as it did before r&r. I acts like it is...
  15. B

    water pump tube install

    HGi I'm having a hard time getting the water pump tube lined after replacing the water pump. I've tried fitting it up into the middle housing and putting it into the grommet on the water pump. So far tube 2 me 0. Does anybody have agood way to do this. Thanks & Take Care Ops sorry 1990 25 hp...
  16. B

    1990 Evinrude shear pin

    Evinrude 1990 25hp motor I'm either missing something or my motor doesn't have a shear pin. Does this mean my prop hub would spin if I hit something? Thanks TJ
  17. B

    Evinrude 25 experince

    Tues we were at our favorite walleye hole. My motor had been idling for a long time at trolling speed. We did change location several times so the motor was run a a higher speed. We were about 5-7 miles downriver and decided to head back . The motor would open up to about 3/4 throttle and cut...
Top