Search results

  1. M

    battery switch

    When hooking up a Guest battery switch which has an off, battery 1, both, battery 2 setting. Should both negative wires on batteries be tied together?<br /><br />Thanks in advance
  2. M

    salt deposits on cylinder head gasket & water cover gasket

    I have a 1996 yamaha 150 and recently replaced the cylinder head gaskets and water cover jacket gaskets. I always have this white salt deposit show up on outside of the gaskets after boating, it is on all areas of new gaskets. I do not see any sign of water leaking from cylinder head or water...
  3. M

    impeller key stuck

    Can anyone tell me how the heck to get the impeller key out the the keyhole. It is really stuck in there good. I have put penetrating oil on it and took a chisel to it trying to knock it out with no luck. I don't want to hit it too hard on the driveshaft for fear of damaging gears in lower...
  4. M

    replacing thermostat 1996 yamaha 150

    My 96 yamaha 150 picked up some sand today and my pee hole kept clogging up with sand and small shells. Everytime I went over idle it would clog again and the overheat alarm would go off. I ran clean water through it at home and it had a good hard stream. I also took out the thermostats and...
  5. M

    wiring 24 volt trolling motor

    I have a 24 volt motorguide trolling motor that came with my boat. The circuit board has been removed and all wires have been rewired into toggle switches. One switch is on/off and the other changes the direction of the motor. There is a green and blue wire that are not connected to anything...
  6. M

    Trailer lights acting up

    My trailer lights are connected to my Ford Explorer using a hoppy kit. All is connected correctly and grounded.When I hit my brakes the lights work but when I turn on my headlights the brake light will not work on the trailer driver side only, it goes off. The same light will not come on when I...
Top