Search results

  1. E

    Wieghts for Old OMCs

    I was curious if anyone knew off of where I could find the wieght to a '90 225 Looper, and a similar vintage 140.... I'm doing a little research before I repower....
  2. E

    '90 225 OMC Stalls Under Load

    This is an update from a thread I had before..... My stbd motor now stalls when in gear. I can get it to crank, start, idle (fast) put it into gear and it just putters out. I tried several times, and it just quits. It will still rev out of gear, but it doesnt sound right.....it sounds choked i...
  3. E

    '90 225 johnny stalls after accelleration

    One of my 2 motors, (the one that ran perfect until yesterday) now stalls after coming down from half throttle plus. She will start up accellerate, run good but as i bring her back down, like off plane, it just fizzles out. It starts up fine again too. It also is idling a bit slower than it used...
  4. E

    Repowering a 25' Tiara Center Console

    As the title says, I'm looking to repower my boat (the current info is in my sig). Friends and family that are into boating are tryin to convince me to get a big single outboard instead of twins. My boat was really designed to have twins, but I have seen a few boats like mine (same hull...
  5. E

    1994 200 Yamaha Overheating

    My dad has a set of 200 Yamahas on his Regulator. They are '94 motors. One of them is starting to overheat at crusing speed. The water pump is working or at least the tell tale. Could it be a bad thermostat? Where / what should we look at first. Both are low hour motors. Thanks, Tom
  6. E

    1990 225 OMC shift trouble

    Recently one of my two 90ish, 225 Johnsons is shifting weird. When I put it in gear at just clutch ahead, it goes into gear, but tends to slip back towards neutral, and clicks just so its part way in gear....(You hear the gears hitting each other) If I surge up a little faster it helps, but...
Top