Recent content by Yamabuki

  1. Yamabuki

    Yamaha 1995 130 txrt

    The motor starts and runs well up to about 4K rpm then when throttle is increased the motor dies or surges, we have fitted a new fuel pump and on motor oil pump control unit. The remote oil tank does not work. What’s the problem please.
  2. Yamabuki

    130 hp Yamaha salt water series.

    Motor starts and runs ok at low speeds but starts to faulter when throttle opened up and needs a touch of choke then runs good at higher speeds.
  3. Yamabuki

    Rub Rail

    We have a 1990 Carver 25 which generally is in very good condition but one small section of the alloy gunwale rub rail is damaged and I would like to replace about 2ft. anyone know where I could get a short piece of rub rail for this boat, used would be fine tks
  4. Yamabuki

    Winterize

    We have a 25 and this will be a first winter. the engine has a closed system so obviously we have put antifreeze in engine side but what about the cold water side, we live on Watts Bar Lake in east TN so not very harsh winters here and we intend to leave boat n the water so we can take winter...
  5. Yamabuki

    Need info please

    We recently purchased a 1980 Carver 25 and have a question about the engine interupt. When we first got the boat the engine would stop dead when changing to reverse, we did some adjustment and now the engine continues to run in reverse but stops when changing to neutral. is there any special way...
  6. Yamabuki

    Which Carver

    We recently bought a 1980 Carver 25 and would like to know what is its Carver name, also is the 25 also reffered to as the 26 or is that a different boat. Would this boat have a hot water tank and if so where is it and is it both electric and engine heated.
  7. Yamabuki

    Garmin GPS

    Our recently purchased Carver 25 is fitted with a Garmin 168 GPS which is no longer supported by Garmin so cant get Navi maps of Watts bar lake etc. Anyone have this unit and were previously able to download maps of the Tennessee river area.
  8. Yamabuki

    Carver 25 handling

    We have just purchased a 1980 Carver 25 and it seems they are quite tender. Any tips on handling, does ballast work. thanks.
See more
Top