Recent content by willamettejeff

  1. W

    Trim / Tilt powers up, however, will not go down

    Below is the wiring diagram for 3-wire T&T. You can find wiring diagrams for your motor and for 2-wire T&T in the Top Secret File sticky post at the top of this forum (Johnson & Evinrude Outboards) in the Wiring Diagrams for Johnson/Evinrude section. Two wire T&T diagrams are at the bottom of...
  2. W

    Plus 1 for Nauticus/Smart Tabs Exeptional Customer Service

    Just want to give a shout out for Nauticus' GREAT CUSTOMER SERVICE that went well above and beyond to make me a happy satisfied customer as they have for so many others. Long story short, I was experiencing a severe prop ventilation problem in all areas of handling in my boat and had determined...
  3. W

    1964 Larson 16' All American Project

    Re: 1964 Larson 16' All American Project I have a 1965 Larson Valero that I rebuilt floor and transom on. I think your going to find that those stringers are hollow fiberglass with just a wood strip glassed in on the top. This is Larson's double hull design. Shouldn't need to do any cutting on...
  4. W

    Tilt/trim wiring, 2 vs 3

    Re: Tilt/trim wiring, 2 vs 3 Below is the diagram for wiring relays for a 3 wire motor. To convert for 2 wire, the black wire (ground/Battery negative) would be attached to the 87a terminals on the relays instead of to the motor. As Chris said, the cable with red, blue, & green 14 or 16 gauge...
  5. W

    Yet another 3 wire 2 wire tilt trim question.

    Re: Yet another 3 wire 2 wire tilt trim question. Here a diagram of 3 wire controller. -- Jeff
  6. W

    how to install a trim and tilt on my1979- 70hp johnson which doesnt have one

    Re: how to install a trim and tilt on my1979- 70hp johnson which doesnt have one Yes, you should just be able to loosen the left mounting bracket and install the T&T unit. Still going to need to take it almost off anyway. Ya, forgot about removing the reverse lock. You will need to do that...
See more
Top