My 1991 Johnson some times is hard to start.When this happens I take the hood off and turn the lever on the primer solenoid, it starts, then I flip the switch back to normal and all is ok. It seems like the solenoid is working because when it is running I push the key switch and the engine...
I have a 1990 70 hp johnson , the VRO is disconected. The boat gas tank has an external fuel pump and a fuel regulator mounted on the boat((1990 15 whaler).I tried starting engine with an external tank and it wouldn't start. Went to the boat gas tank and it started fine. Any ideas on what was...
My engine was surging, I found the cause was the temperature sensor on the block. When I disconnected the wire the engine runs fine. When I put my hand on the head it feels cool and the tel tale is working fine.I rather not run it without the sensor. Any ideas?
I had a problem with the coil and the points, I resolved that problem and was able to start the engine. I ran it for about 15 minutes on and off. Towards the end I could not pull start the engine. I pulled the dip stick and found that the oil looked like a milk shake. After a while I took off...
I just picked up a Bf1oo that is not running, but it looks very clean. I am not getting any spark, so I checked the coil, it looks like it is open on the secondary side. The coil is obsolete. Any one know where I can get one?
I want to replace my water pump this weekend. Can I put the boat in the water right away or do I have to wait for gasket sealant to dry first. And if so how long.
I picked up a 13 foot boston whalet Sport 2 years ago. Initially had a problem with primer solenoid, after replacing solenoid(leaking fuel into carb) engine idled fine. Over winter and spring I restored the hull and changed head gasket water pump, and rebuilt the carburetor.. After restoration...
I have a 2000 200 hp optimax. The engine is intermitant at high rpm. I took the boat out two times this year and was hoping it would clear it self. Some times it picks up on its own. I asm guessing clogged injectors. I was thinging of putting some tecktron in the fuel water seperator and running...
I have a 1991 evenrude 30 hp . I went to rebuild the carb and found out that my engine calls out for a 432705 carb I have a eq432703. I knew some thing was funny with my carb because there was a needle valve threaded in the orifice plug ( number 1 on the diagram) and no nipple on the float...
I just puchased a 13 foot Whaler with a 1989 evenrude 30 hp engine on it. It is electric start, but the starter drive gear is not working. I was able to pull start the engine, it started right up but would not idle, after i let it idle down it stoped and wouldn't re start. The previous owner...
I just puchased a 13 foot Whaler with a 1989 evenrude 30 hp engine on it. It is electric start, but the starter drive gear is not working. I was able to pull start the engine, it started right up but would not idle, after i let it idle down it stoped and wouldn't re start. The previous owner...
My engine stalls at idle. If it does not stall it sounds like it is missing. Once past idle the engine runs fine. @ 3000 rpm the engine light comes on ( indicating a sensor problem). While crusing the engine runs fine. @ idle it seems like it is missing.
Checked plugs, coils ,crank position...
