Recent content by royal50

  1. R

    changing impeler

    So I decided to change out my impeler on my 94 force 120 and when i removed the lower unit and I was dropping it down the seal that is above the long shaft came down as well. After having such a hard time to put it back up there because of the space, my neighbor told me that the seal should of...
  2. R

    What prop to use

    Which prop should I use for my 94 Force 120? I believe it's a dual exhaust. I currently have a 17" pitch on it but it takes too long to get on plane and it struggles. I should also add that I like to use my boat to pull inflatable tubes, wake boarding, etc. it's on a 18" bayliner.
  3. R

    Tell tale not working properly

    I have a 94 Force 120 that has the buzzer going off a WOT. I thought it might of been my impeller so I checked it out and everything looks good. I also changed my thermostat and the buzzer still goes off. I took the boat out yesterday and did noticed that the tell tale only pisses at low...
  4. R

    Differences in force 120

    Is there a difference between the years in a force 120? I have a 94 and I was wondering if a 95 would be the same. I'm looking to purchase a temp sensor from eBay but is listed as a 95. I just want to make sure it would work with my motor. I took the serial number off my motor but it does not...
  5. R

    Won't stay running

    So this is really weird. I have a 94 Force 120 and for some time now it's been running bad and I haven't been able to figure out why. It was only running when the throttle was all the way forward in the fast idle position. And then as soon as I backed up to neutral it would die. Well, today...
  6. R

    94 Force 120 help!

    I have a 94 Bayliner with a 94 Force 120. I took the boat out today for the first time after being winterized for the winter. It started fine and took the boat for a couple of laps. After a few laps I stopped the motor and I sat there for a while. When I went to start it, I pushed the...
  7. R

    Putting back the impeler

    I love this forums, you just learn so much from them. Now that the impeler step by step change was explained, all I need to know is a couple of things. When I put the gaskets back on the water pump housing, do I need to put any type of gasket sealer? Also, do I have these two rubber seals in...
  8. R

    120hp Force not shifting into gear.

    I just recently purchased a used bayliner that came with a Force 120 and a small Mercury kicker. I took it out today and a couple of hours after tubing around the lake, the motor started acting up. When you start the motor in neutral it will start just fine but as soon as you put it in gear and...
See more
Top