This started with the outboard not being able to trim up under load, and running really slow on the tilt ram. So I put new seals in it, cleaned everything up. This included disassembling the pump to clean out all the oil as it had fine metal flake in it. Also put a new electric motor on as the...
Re: 1993 Evinrude 2 stroke 40hp lack of power from mid throttle on.
What kind of gasket are you saying goes on the high speed jet Boobie? The parts below are the remaining parts left over from both carbs, after the rebuild minus the obvious parts that aren't used. Although I have the parts, for...
Engine runs great at idle, smooth up towards mid throttle, then falls flat on its face and starts misfiring. From an idle I can whack the throttle open and it jumps out of the water for about two seconds, then falls flat on its face. Pulling the choke out ever so slightly feeds it extra fuel and...
Re: Some friendly advice needed please
Since it is a small boat and you will always be in it, I would vote for a small mushroom anchor and maybe 4ft of chain...maybe. No need for a 3:1 scope as it is a light boat and again you will be onboard. If the anchor slips you can just reset it. I have...
I have a 1993 Evinrude 40hp (40RETB) motor that I added a starter and starter solenoid to (It was rope start originally, so now I have the best of both worlds). Right now at the end of a long weekend, my battery which is a Hawker Odyssey is pretty much dead from starting the boat and running a...
I started running the battery of tests as I have the OEM manual, but so far everything tests good. I figured I would run it by some other people and see if they know what it "could be". The boat and motor are new to me but have minimal actual use.
The motor is a pull start 40 horse E40RETB of...
