Recent content by kyong1

  1. K

    Yamaha 115hp 2011 4 stroke idle not adjusting properly

    You can say that again 😂
  2. K

    Yamaha 115hp 2011 4 stroke idle not adjusting properly

    Marine shop Yamaha mechanic fixed the problem.. injector cleaned and computer idle done great job extream on labor cost to the moon and back...,😎
  3. K

    Yamaha 115hp 2011 4 stroke idle not adjusting properly

    Thank You for replying off to marine yamaha shop :-)
  4. K

    Yamaha 115hp 2011 4 stroke idle not adjusting properly

    After going into limp mode returning to boat ramp and solving the fuel leak and oil from lower unit seals . Replaced fuel pump, water pump and had done the 300 hr service idle went erratic since .I had attempted adjusting to higher 800rmp .but still up and down..
  5. K

    Wiring Nightmares

    Problem fix fuel injector oring torn
  6. K

    1986 30hp johnson overheated and now won't start

    Wire harness caught fire I gave the boat away to lawn mowers guy....and got another boat a year later
  7. K

    Yamaha 115hp 4 stroke 20mph only????

    Thank for all reply s
  8. K

    Fuel coming from pee hole

    Thank you for your response, disconnected from the top and seems like only water coming out while running.
  9. K

    Fuel coming from pee hole

    Before this happened boat alarm went on. I shut it off turn back on and went to limp mode getting back to ramp and fishing trip ended.
  10. K

    Fuel coming from pee hole

    Where is the problem, the fuel cooler 2011 Yamaha 4 stroke 115hp.
  11. K

    Flushing port leaking oil

    Yamaha 115hp 2011 leaking from flushing port when lower what seal could be damaged.
  12. K

    Yamaha 115hp 4 stroke 20mph only????

    My Carolina skiff 198DVL only ride at 20mph at full throttle.. With a 115hp 4 stroke 2011 I feel Yamaha should go faster... change d sparkplugs; fuel filters; all oils. What could the community recommend. My appreciation thanks 😑 inshore fishing
  13. K

    Yamaha 2000 115hp v4 6 trim tilt not working after change of seals

    Changed all cylinder seals after a problem with lowering tilt and now I only hear the motor running. Numerous times I have bleed assembly and taken the cylinders apart. I t seems there is no pressure. I have tried troubleshooting as well checking relays and motor Appreciate any input..Thanks
  14. K

    Power tilt will not raise Yamaha 2000 115hp v 4 not oil

    power tilt motor work and attempted to fill but won't raise 115hp 2000 yami
Top