Just purchased a used one of these and the 14 wire control box as well. I want to make sure all electrical systems(not ignition) are working, prior to firing it up. Tilt n trim seems to work, as well as the warning buzzers. I cant seem to get the starter motor to crank. Question is, what...
Back then we could look at an exploded view of an engine that showed general assembly and part numbers. Tell me- did anyone copy these diagrams to the internet? Where are they? I threw out my MF viewer about the time Pentium came out. Is there a site or many that this information is archived in...
so i bought one through ebay-- it's a 45 hp bf45a with power tilt and trim and electric start. it was primarilly used in salt water a few years ago, (in storage since) and if possible i would like to do what i can to maximize it's life. it will never be run in salt water again by me. it has not...
Had a member here say I needed a gasket between motor and lower unit shaft. Talked to Rude dealer today (he was very nice) ;) But, he said no Gasket used there. Whatsup??
Does any one in this forum have a parts book for Johnson 1992-1993 30 & 40 HP motors. I need to compare the two electric starter assemblies and respective part numbers<br /><br />Thanks <br />Ksan :)
I have a manual start 30 HP 1992 Johnson mdl. J30RENR. I found a guy on line that has a electric start 40 HP 1993 Johnson mdl. J40TLETB. Could some of you tell me if at least the starter parts (including flywheel) on these two engines match up enough to use on my earlier model?<br /><br />Thanks...
My Grabdfather and Father taught me to say "Rabbit" on the first of every month and I had to say it only once and before noon, in order to have good luck in the month to come. Well I am 58 now and have had a few sour months since meeting a lady friend that says I have it wrong. She says I should...
need to make a gasket between upper and lower unit on a 18 HP 1962 Evinrude Fastwin. Unit already has the metalic gasket plate in place and in good condition. What gauge gasket will do the job?<br /><br />Thanks,<br />Ksan
as title says, NE1 know if the starters, mountings, flywheels, solinoids, etc are compatible between 1993 40 HP Johnson and 1992 39 HP Johnson?<br />Thanks Ksan
cut weinies in half lengthwise,and place in baking dish you never want to use again, pour on catsup, some mustard, Worstershire sauce, brown sugar, bake forever till about black- you will love them<br />Ksan
I need to replace the vertical pot metal bracket that allows the mixture knob to rotate. And I also need a wiring harness as well. Could you point me at a likely parts house online? If I can't get a wiring harness, does anyone have a wiring schematic for this engine?<br />Thanks<br /><br />Ksan...
I need to replace the vertical pot metal bracket that allows the mixture knob to rotate. And I also need a wiring harness as well. Could you point me at a likely parts house online? If I can't get a wiring harness, does anyone have a wiring schematic for this engine?<br />Thanks<br /><br />Ksan
I have one of these SER# J30RENR, Where can I get parts needed to add electric start/choke/wiring harness and Is there a place to get same parts used?What is most likely parts house for these items?<br /><br />Thanks,<br />ksan
