I am looking for help on how best to do fiberglass repairs. I have a Bayliner Trophy. My fiberglass has holes drilled I'd like to fill and some good chips. I wasn't sure if best to fill with straight fiberglass or mix up some peanut butter. Or use a epoxy filler? But my biggest question is how...
Trying to help a retired veteran get fishing. Old Honda B75 7.5
Here's what I know. No spark, it's non cdi
So that leaves the
- ignition coil
- pulser coil
- points and condenser
- charge coil
- oil pressure sensor
- no rectifier. Not sure if it's missing or just didn't come with one 🤷
It's...
Thanks I ordered this up in dark gray. Should I roll it on with a smooth paint roller or should I use something that would give it more texture or does it even matter? Also my biggest question what do I need to do to prep the surface do I just wash it really good or do I need to wipe it down...
I have a 20 ft trophy with an outboard and when I go to fuel up I can barely put gas in slowly otherwise my tank pressurizes and blows gas back out to put in $10 literally took me like 15 minutes. My tank has a 5/8 hose coming off of it but the problem is the vent going outside the boat has tiny...
Bayliner trophy, anybody have this problem my deck is so white that when the sun is shining on it it literally blinds me, and even if I wear sunglasses all day I end up with an awful headache from the bright glare.. I'm wondering if anyone else has this problem and has put any kind of a coating...
I just bought a 21-ft trophy and it looks like they rolled on some black bottom paint and also it looks like there's some primer above that and around it wondering how to remove all of this garbage and get back down to the gel coat
ok found my wires coming from control, no idea where to connect on gauge. i have 4 spots, obviously one is ign 12+, and a ground, other 2 dont make it work?
I have a 2005 DF200 and boat was stripped, got this motor and controls now and threy didnt connect my trim gauge.
coming off of the front of the control box not connected to anything and headed up to the helm is a white wire with a yellow stripe and a black wire , and a red wire with a gray or...
i have 2 vacuum lines and 2 empty ports, i dont know which one goes where.
1 - the one coming from next to the air intake
2- the one coming off the VST
and the 2 empty ports are under port side of the intake and then on the oil pump