Recent content by johno77

  1. J

    blackmax 200hp 1989 problems

    , two blue ,two red, two yellow and one black
  2. J

    blackmax 200hp 1989 problems

    Just wondering is there supposed to be continuity between the black ground to red/white? their also continuity from black to single red on the stator
  3. J

    blackmax 200hp 1989 problems

    cheers
  4. J

    blackmax 200hp 1989 problems

    Thanks Good idea
  5. J

    blackmax 200hp 1989 problems

    does that involve all the wires including the wires that go to the coils?
  6. J

    blackmax 200hp 1989 problems

    I did some more testing, dva tested trigger, stator ,coils and packs. All tested good apart from trigger low voltage 2.2v.I then removed idle/stabilizer wires and voltage came back up to spec on trigger. I also did this test(not in the merc manual I have). Hopefully I worded it correct. I...
  7. J

    blackmax 200hp 1989 problems

    I get confused easy haha. Ill send a video link hopefully tomorrow .
  8. J

    blackmax 200hp 1989 problems

    okay slowly learning the regulator and rectifier are two different things yeah? I just haven't read about them yet in the book I have. My workshop manual in some parts bit hard to understand its fallen to bits.Is the idle stabilizer on top or on the port side? There's two black boxes that look...
  9. J

    blackmax 200hp 1989 problems

    Thanks for the reply 16amp Oh and its a 1989 model
  10. J

    blackmax 200hp 1989 problems

    Hi, I am having problems with my mercury 200HP.1989 not 1998 I redid the carbys 2 years ago. The engine has been sitting. I took it out a few weeks ago. I put in fresh fuel and some sea foam. I ran it on the muffs a few times during the week before heading out. Most of the carbon was gone. Not...
  11. J

    200hp outboard mercury blackmax swivel arm bracket engine is around 1986model and sea star steering.

    Thanks for the reply. Washer goes on top of bottom yoke will I have to take power head of ?
  12. J

    200hp outboard mercury blackmax swivel arm bracket engine is around 1986model and sea star steering.

    I replaced my old swivel arm bracket about 18months ago.Iv finally got around to putting lower unit back on.Looking in my box of parts I noticed a wave washer.Looking at swivel arm bracket looks like I did not put it in. Would this cause problems if I was to leave it of? And if i do put the...
  13. J

    filling holes then re drilling in bottom of fiberglass ski boat to fit Finn

    Looks to be fiber glass, ply then gelcoat.
  14. J

    filling holes then re drilling in bottom of fiberglass ski boat to fit Finn

    Holes are bigger then what I said probably 6-7mm bigger. Here is a link to videos Thanks for your time.
  15. J

    filling holes then re drilling in bottom of fiberglass ski boat to fit Finn

See more
Top