OK rebuilt the carbs, filled the jets clean, rebuilt the VRO, got it started by making the idle higher and it will run over oiled. I have made the choose to delete the VRO for now. MY plan is to cut the oil line to the motor from the tank putting a bolt in and clamping. From there mixing the...
I rebuilt the VRO and then got a no oil light. I check the oil level it's 1/2 way down not too low but filled back up. The engine runs but still has trouble with reving, I rev up and it stalls out. Still blowing too much smoke. Any ideas?
Sorry boat repair dumb is the fuel pump 1 or 2? Both have a good seal and not warped. In water is a gas oil mix so I was assuming that like a car with out a cat it dumps unburned fuel into exhaust and into water
Yeah carb throats, they filled the bottom of the cover with oil gas mix. I cleaned it all out. I know they may drain a bit.
The smoke was white with a blue tint( according to my wife) I saw white lol,
That oil gas in water was pouring outta my exhaust Everytime I went to start it would start...
Hey y'all,
ok here is the situation, I went to start my boat to warm it up, and a large cloud of white smoke plumed into the air, not abnormal, except it was not stopping and the motor sounded like it was rough idling. It ends up stalling out. After that I would continue to try and start with...
Ok update..
Took it out today again. Was able to go to 3k rpm. Overheated, flame arrestor has water n gas inside, carb has water on top screw, oil is clean but overfull by a quart or so... Ideas?
So I got my boat fixed up, new risers and manifolds, engine coupler, all new plugs, new starter.
Took it out for a ride everything seemed good went to get moving and as soon as I go over 2200 rpm boat shakes seriously, and it sounds like it's choking itself out. Almost as if the carb is dirty...
