2019 honda bf150 with 70 hours. Trying to diagnosis an dtc 14 - iacv problem. Port Engine throws a code as soon as it starts, but runs. Sometimes it stalls as cranking, but once it gets running, idles fine, and no performance issues. Its only throwing code 14 when starting up.
Before pulling...
2002 Cape Craft, with 03 Honda 200hp. I'm experiencing a recent issue where when I try to turn on my deck halogen lights, or use my horn for example the voltage is dropping significantly. The lights, radio, and stereo are on a different wire than the horn wire. Regardless, I have good batteries...
Bought a Safe-t-Alert Gasoline detector for safety reasons. Placing it in the outboard motor but should I place one under the boat deck too? Or is there not much of a risk of explosion under the deck when you have an outboard motor?
I have a 2002 Cape Craft 22cc its a center console with an 4stroke outboard and a 80 gallon plastic fuel tank. It also has a small walkin cabin for a porta potty and has drain. Whenever I take the boat traveling and even sometimes sitting the small walkin cabin will have to me a strong fuel...
I just re-cleaned on my water fuel separator and fuel pump. I did this before but this time have a weird problem when I put everything back.
I turn the motor over runs GREAT now, however fuel is pouring out a tube connected to the front side of the motor. Pic included.
Where does this tube...
I have a few car pump laying around that still work. I have a 03 honda outboard 200 hp. I have a fuel pump from a 99 honda accord that was replaced due to an upgraded fuel pump. The pump seems to fit inside the High fuel pump housing quite fine except the top of the fuel pumps electrical...
I have a 2003 Honda 200hp but just need your experience with outboard fuel system. Trying to diagnosis a fuel problem. My Honda has a low pump #8 IN DIAGRAM (top of cylinder head cover) High Pressure pump(attached to the side of vapor separator). A few questions.
1) When high pressure pump...
2003 200 hp honda outboard. I know I have a fuel issue but can't figure out where the problem is. I have had the same fuel in the tank for a few months now and when I ran it last the motor died out. I thought it I ran out of gas so I bout some 100% gas to be able to run it again. Well the motor...
Had an issue with a port side trim tab actuator, sent the unit to Bennett Monday within 3 days I had a BRAND NEW Actuator at my door today. warranted out with no hassle! THANKS BENNETT I will post this in my local pensacola fishing forum and added you to my FB "likes"
Im trying to move and raise my live bait bucket higher up (right now it sits on the deck). Im trying to use 2x4's (homedepot kind) and have it all cut out and planned.
Should I paint the wood would or something to help prevent rot and mold from being outside? the wood will be below the bait...
I have the bennett sport tab i believe its the m80 model with the trim tab indicator with seperate controls for the trim tabs. The starboard side works fine the port side is stuck open. Heres what i have done so far.
Cleaned all connections at helm and gound wire from the hpu to the battery...
Order a Tempress Boat hatch. Installed it very good construction and weatherproof which is what i was mainly looking for. So I ordered another one very good price too. The 2nd one had a pinched weather seal looked like a honest mistake.
Contacted the Great Lakes Skipper and all I wanted was...