I found the part number I need but apparently there is a old version and a new version. How do I figure out what to order to replace it? Its 839696. Is there a thread size I can check on the out drive or something? Where can I get a new bolt?
1985 Volvo AQ125A / 270 on a sunbird cuddie cabin
My engine overheated so I took a look and the coolant was empty. Dipped a bucket in the lake and filled it up. Next day same issue again. Its leaking to empty in a day. It has a new to me used and tested heat exchanger last year. Where should I start? The boat is currently 300 miles away...
How can I get a good seal in my 270 outdrive? The drive is sucking air when up on plain. Should I just put a sea **** in the floor of the boat. This system seams to be an issue every time i get the boat out.
I have decided to put one on my 85 AQ125A. Can anyone help me find into on where to place it and the best set up? Please don't waste your time trying to convince me to use the intake thru the leg. Not happening. Too many issues year after year.
I'm saposed to go on vacation with boat tomarrow. I am not getting any water into my impeller. I pulled black hose from neck on outdrive and blew on it and it held pressure. Put it back on and tightened it very hard drolled leg in bucket but still no flow to heat exchanger. My nieghbors are...
I took my boat out yesterday and it ran fine and started and shut off a couple of times with no problem. Untill the last time It would turn over buy would not start. Luckilly after a good five minutes of on and off trying and a can of starting fluid out of my emergency box it started...
Ok I have a 85 sunbird aq125 270 that when I go from 4000 rpm to idle rapidly the boat will clunk like the outdrive hit something and the boat will throw you forward a bit. Also now the boat waits to shift into forward and clunks when it does. I found a 275 for sale for farly cheap and was...
I have an AQ125A Volvo with a 270 outdrive. My outdrive will move if i push it down with my wieght. About 200 lbs. Also i have had trouble with the paws working and the light stays on all the time. Whats the deal?