SDSeville
Lieutenant
- Joined
- Mar 19, 2010
- Messages
- 1,481
Hi Everyone,
I am going to make a triangle dock box to mount next to my slip, similar to this one -- http://www.ebay.com/itm/Taylor-Made-...-/131585776772 but hopefully at a fraction of the cost. My harbor requires them to be premade and of fiberglass, however I have seen many DIY boxes around there. My thoughts were to use 2X4 and 2X2 framing with 1/2" plywood. Then cover the outside with poly resin and CSM and paint white. It should look better than most of the DIY boxes I have seen around there. Should I go with 1708 before the CSM? Any suggestions or better ideas appreciated. Thanks!
I am going to make a triangle dock box to mount next to my slip, similar to this one -- http://www.ebay.com/itm/Taylor-Made-...-/131585776772 but hopefully at a fraction of the cost. My harbor requires them to be premade and of fiberglass, however I have seen many DIY boxes around there. My thoughts were to use 2X4 and 2X2 framing with 1/2" plywood. Then cover the outside with poly resin and CSM and paint white. It should look better than most of the DIY boxes I have seen around there. Should I go with 1708 before the CSM? Any suggestions or better ideas appreciated. Thanks!
Last edited: