Substitute for 317002

[jitterbug127]

Hello! I am currently adding some outboard tools to my shop.
My short list
1. Ultrasonic cleaner
2. A better spark checker
3. New Carb cleaning brushes
4. Long telescopic magnet
5. No taper screwdriver for carbs

I haven’t broken the brass fitting on one yet, and I’d like to keep my streak alive: the 317002 is $50-60 on eBay. I’ll pay that but I’d rather get something suitable that is cheaper. Briggs and Stratton 19061 is on eBay for $20. I wasn’t sure if this would work? Do y’all have another suggestion or is best to just bite bullet on 317002.

Thanks and have a blessed day!

 

[dingbat]

You might want to look at the screw drivers made specifically for DIN Rail terminal blocks.

Hardened chrome steel tips. Available in tip widths ranging from 2.0 to 6.5 mm in 0.5mm increments

I "borrowed" one from work many moons ago and it has yet to fail me. Have yet to run into an application it didn't fit.

Best part $12 or so

Schlitz-Schraubendreher | Weidmüller Produkt-Katalog

catalog.weidmueller.com

 

[F_R]

SerSee

You might want to look at the screw drivers made specifically for DIN Rail terminal blocks.

Hardened chrome steel tips. Available in tip widths ranging from 2.0 to 6.5 mm in 0.5mm increments

I "borrowed" one from work many moons ago and it has yet to fail me. Have yet to run into an application it didn't fit.

Best part $12 or so

https://catalog.weidmueller.com/pro...6?groupId=("group32140773349121")&page=Group[

 

[F_R]

See the picture I posted on aomci.org where you asked the same question. Less than 5 bucks and I promise it will work just fine.

 

[jitterbug127]

See the picture I posted on aomci.org where you asked the same question. Less than 5 bucks and I promise it will work just fine.

I’m gonna order a few. I’m sure I’ll lose one!