Broke impeller shaft help!

Tkilkenny

Seaman
Joined
Jul 21, 2023
Messages
56
The impeller shaft broke today out on the River. What would cause this? Not sure what to do. Found a replacement water pump shaft but I don’t know if I need bearings, seals gaskets or anything else. I will probably have to have a marine shop do the install
 

Attachments

  • IMG_0520.png
    IMG_0520.png
    279.9 KB · Views: 3

dubs283

Vice Admiral
Joined
Jul 27, 2005
Messages
5,129
Definitely seals and gaskets as you need to fully disassemble the upper drive half to replace the shaft

Might not need to change the shimming, bearings and gears but the only way to know is by inspecting and measuring with the new shaft installed
 

Tkilkenny

Seaman
Joined
Jul 21, 2023
Messages
56
Ok any idea or ball park what parts and labor would cost for this type of repair? I did notice some transom oil around the broken shaft
 

dubs283

Vice Admiral
Joined
Jul 27, 2005
Messages
5,129
Ok any idea or ball park what parts and labor would cost for this type of repair?

No clue

But you'll most likely have a tough time finding someone who will work on it. Have to find a shop willing to work on older stuff with someone capable of doing the work properly. Maybe an independent guy who works primarily on sterndrives, there's a few around

What is transom oil?
 

Scott06

Vice Admiral
Joined
Apr 20, 2014
Messages
5,676
these guys sell reman units assume they could rebuild yours


I think they rebuild them too
 
Top