Search results

  1. C

    Adding electric start to a 96 Mariner 30hp

    Hi Newbie here, adding electric start to a 30 hp outboard. I've included electrical diagram I'm using . Wiring in the existing stop switch (from the tiller handle) and adding a kill switch seemed pretty straight forward (black to black, black/yellow to black yellow leads already prewired on the...
  2. C

    Swapping Short and Long Shafts between outboards

    I would like to know if it is possible to swap the lower units between a Mariner 30hp short shaft (serial#0G193173) with a Mariner Magnum 40hp (0G137689) both seem to be in the same time bracket. I understand that the mounting bracket is different since the 40hp has tilt trim. Thanks
  3. C

    Achilles floor replacement

    Hi everyone, I have a used Achilles 14 with badly deteriorated plywood floor sections. I would like to separate the aluminum extrusions/frames from the old plywood but looks as though the plywood was press fit into the extrusions (and probably some wood swelling as well). Is there any trick to...
  4. C

    Achilles plywood floor replacement help

    Hi everyone, I have a used Achilles 14 with badly deteriorated plywood floor sections. I would like to separate the aluminum extrusions/frames from the old plywood but looks as though the plywood was press fit into the extrusions (and probably some wood swelling as well). Is there any trick to...
  5. C

    reusing the aluminum extrusions from floor boards

    Hi everyone, I have a used Achilles 14 with badly deteriorated plywood floor sections. I would like to separate the aluminum extrusions/frames from the old plywood but looks as though the plywood was press fit into the extrusions (and probably some wood swelling as well). Is there any trick to...
  6. C

    Rubber seal around pull start for Nissan NSF30A Cowling

    I cannot find this seal in the parts manual, does anyone have a source for this part, new or used. I've enclosed an image ..thanks
  7. C

    Switching 25hp Nissan electric start/charging over to a 30hp Nissan

    Hi, I just bought a 2002 Nissan NSF 30hp with manual start, I also have a 2002 Nissan NSF 25hp with both manual and electric start. I would like to switch over the electric system from the 25 to the 30 and sell the 25hp as a manual start. Is this in the realm of a do it yourself mechanic. Is it...
  8. C

    Nissan NSF 2002 25 hp No water out the pee hole

    I went to start up my Nissan outboard today and no water is exiting the pee hole, just warm air. (The prop and intake were fully submersed in a large bucket) Pulled off the thermostat and it's bone dry inside no clogging. Is it the impeller? Motor has about 60 hrs on it tops. Always operated in...
  9. C

    Nissan NSF 2002 25 hp No water out the pee hole

    I went to start up my Nissan outboard tofay and no water is exiting the pee hole, just warm air. (The prop and intake were fully submersed in a large bucket) Pulled off the thermostat and it's bone dry inside no clogging. Is it the impeller? Motor has about 60 hrs on it tops. Always operated in...
  10. C

    Hi Urgent Nissan Motor repair

    I'm located in London Ontario. I have a Nissan 25hp four stroke NSFA 2003 serial # 030776XC. I noticed a hose connector broke off on the vacuum?? section of the top carb (see picture) and the motor has been slamming into gear. I'm in a bind to repair this and the closest Nissan dealer is a...
Top