Search results

  1. A

    Infamous Minnkota V1 powerdrive control board fail 12v. vs 24v

    Got bit. ….ugh Ive read you can replace V1 board with a V2 control board. and must splice the pedal wires Ok Question. my V1 is a 12v. ……..has anyone replace a 12v control board with a 24v control board Either using v1 or v2? mix and match? i do have soldering skills. thx
  2. A

    Grumman 14’ fisherman floor coating 1990

    Looking at a used boat . Appears to be some rough grey blue coating on the floor. Eg anti skid Factory or aftermarket ? Thx
  3. A

    Help 1988 Bluefin 15’ voyager ? 1500 or catalog

    Bought a used boat. No name plate . Is a 1988 blue fin per the serial number. Looks to be the voyager modrl? Anybody have a photo of this model in its original or restored form. Thsnks
  4. A

    Seeking brainstorming ideas from experienced hull rivet gluvit repairs for a 1995 grumman lowe sea nymph sport deck stinger deck boat issue

    Seeking brainstorming ideas from experienced hull rivet gluvit repairs for a 1995 grumman lowe sea nymph sport deck stinger deck boat issue 1 Procured boat from now defunct dealership with intent of restoration 2.Dealer had cleaned up boat and applied a coat of “bottom paint” he stated...
  5. A

    1989 Evinrude 88hp zerk grease fitting locations midsection

    Anyone have a diagram showing zerk fittings on the midsection? EG the shaft sleeve which the motor midsection pivots left or right when steering? My steering cable is fine and i have lubed the outboard tube in which it clamped Now Looking for zerk fittings for that vertical portion thx
  6. A

    1987 mercury 70 hp mystery hose lower unit

    Finally got the beast repaired ,running and shifting correctly. this mystery hose in the lower unit. All i can think is it if for a speedometer sensor?
  7. A

    1988 Evinrude sp88 fuel prime loss

    Engine works ok. I squeeze the prime bulb before starting Choke it. And usually starts right up after a few grinds Issue is I am out on the lake fishing for an hour. and it loses the prime. i must squeeze bulb to get it firm. it then will start . I find zero leaks in the line...
  8. A

    A 1988 70 hp mercury Wme carb question - see photo

    What is the orifice hole indicated in yellow? What is screw needle next to it?
  9. A

    Tight steering under power one direction only

    Five year old teleflex NFB rack steering 19 runabout Looose and free both directions out of water Same at the dock All zirc fittings greased Under load at high speed difficult to turn starboard direction i believe Thoughts ?
  10. A

    1969 mercury 3. 9 hp. impeller and housing replaced. stream low

    Replaced impeller and impeller plastic housing More pee squirts at low idle. than at high rev. Never a strong stream Thoughts? impeller key slipping maybe.? Had it apart 4x and can’t figure what else may cause
  11. A

    Seafoam. good bad or ugly?

    Have a 70 hp 2 stroke sat for 4 years. seems to idle a little low or rough Any value in running a tank with seafoam in gasoline? Mix ratio? Duration.? Ive never used Seafoam
  12. A

    1985 johnson 6 hp. 100:1 mix correct?

    Decal on the motor says 100:1
  13. A

    50:1 or 40:1. mix ratio for 1987 mercury 70hp

    am disconnecting the oil injection. what is the correct mix?
  14. A

    Are these throttles labels interchangeable

    One is easier to understand. lol 1985 6hp evinrude
  15. A

    Blue lower unit fluid leak. 1988 70hp. when i turn on the garden hose muffs

    I suppose it’s a internal seal. Turn on the water garden hose muffs and watery blue goo dripping from where prop meets gear case Thoughts on what parts i should order before i drop the lower unit? any secret tips .? thanks. appleo
  16. A

    1986 Merc 70hp power trim motor removal - Help I am Stuck !!

    Trying to remove power trim electrical motor One hex cap head screw and its loose Pried motor up but not enough clearance to remove......Have a a look ! Ideas?
  17. A

    No cranking on 1986 Merc 70 - Help!

    Merc 70 Motor sat for 2 years Checked it over and hooked to a used 5 yr marine combo starting/deep cycle battery (battery worked fine last year trolling minnkota) Merc 70 Starter relay picks and clicks but no starter bendix spin Power trim relays picks and clicks but trim motor wont spinup...
  18. A

    Mercury Gen 1 or Gen 2 control box cables?

    which are correct for this 1986 merc 70 hp?
  19. A

    Throttle cables omc vs mecury

    Simple question. are they interchangeable Omc cables and mercury cables. esc eg an industry standard
  20. A

    Any Mercury Outboards prior to 1990;with factory trim sender? Please sound off!

    Trying to determine if i can possibly add trim sender to my 1988 70 hp. Aand when Mercury started adding factory senders
Top